Front panel

Parent chapter  Previous page  Next page



Lyra's front panel contains a limited number of physical controls and indicators.  A greater degree of control is available using the Lyra Control Panel app software provided.  The front panel also contains the instrument input and headphone output jacks.


From left to right:


Instrument input jacks 1&2: mono unbalanced jacks, high impedance, with finely adjustable gain control. See Analogue inputs. Note that Lyra 1 has only one instrument input.


Meter panel: see below.


Assignable level control: Volume knob which can be assigned to any of Lyra's outputs (except for the headphone output), as required.  This is primarily intended as a monitor volume control for stereo monitoring.  Note that pressing the knob mutes any outputs assigned to the control; this state is indicated by the LED halo around the knob flashing.


Headphone jack: with its own volume control.


Standby button: puts the unit into a low-power standby state.  Note that the USB interface is still active in standby mode, so the Lyra unit can still be recognised by the host, although its inputs and outputs are inactive.  The LED in the standby button flashes to identify the unit in multi-unit setups when the 'Identify' button in the Control Panel app is clicked.  Entering standby mode causes Lyra to retain its current software control settings in flash, for example for use in stand-alone mode.



Meter panel


The meter panel contains metering for the analogue input and output channels and the S/PDIF input and output channels. It also contains the input selection indicators and Overkiller activity indicators for all the analogue inputs, unlock and SRC indicators for the S/PDIF input, and an SRC indicator for the S/PDIF output.



From left to right:


Input selection indicators: these indicators show the analogue input selections; green for line, or pink for mic or blue for instrument preamplifiers. The mic selection indicators change from pink to red to indicate that phantom power is switched on. See Analogue inputs.


Master indicator: this is lit when the device is set to local (internal) sample clock, and off when locked to an external sync source; it flashes when local sync has over-ridden an invalid external sync source selection. For more information see the Synchronization section.


Meter input/output indicator: shows whether the bar-graph meters are assigned to the analogue and S/PDIF inputs (IP indicator is lit), or to the analogue and S/PDIF outputs (OP indicator is lit).  This is selected in the Lyra Control Panel app. See the Metering system section for more details. Note that in the case of Lyra 2, the analogue output meters may be selected to outputs 1/2 (OP indicator is green) or 3/4 (OP indicator is orange).


Overkiller indicators: indicate that the Overkiller progressive limiter is operating in that channel.  Note that the indication is dynamic, and shows when the Overkiller is actually limiting, and not simply that it is enabled.  Note that the Overkiller indicators are only active when the meters are in input mode.  In output mode, these indicators flag a Verifile checker error in the corresponding DAW output if that signal is Verifile-encoded.  If the signal is not Verifile-encoded, or if there is no error, the indicator is not lit.


DI unlock indicator ('UNL'): indicates that the S/PDIF input is unlocked, i.e. no S/PDIF carrier is recognised; only active when the meters are in input mode.  In output mode, this indicator flags a Verifile checker error in either channel of the DAW DO output if it is Verifile-encoded.  If the signal is not Verifile-encoded, or if there is no error, the indicator is not lit.


SRC indicator: shows that the SRC (sample-rate converter) is configured in the S/PDIF input (when the meters are in input mode) or is configured in the S/PDIF output (when the meters are in output mode).